Hpe Smart Array S100i Sr Gen10 Sw Raid Driver For Windows Server 2022 ((link))

Open diskmgmt.msc . Your RAID logical volume(s) should appear as a single disk with the correct capacity.

from HPE Support Center — search for your server model and filter by “Driver – Storage Controller”. Open diskmgmt

| Issue | Likely cause | Solution | |-------|--------------|----------| | Drive not seen during Windows install | Driver missing | Load S100i driver as described above | | Windows Server 2022 fails to boot after enabling RAID | Boot order or driver conflict | Boot into recovery → load driver, or reinstall OS with driver | | Poor performance on RAID 5 | Software RAID overhead | Use RAID 10 or hardware RAID for better write performance | | HPE SSA cannot see controller | Outdated driver or missing chipset drivers | Update S100i driver and chipset drivers | | Issue | Likely cause | Solution |

You can download the verified driver directly from the HPE Support Center . Use the correct one, and Windows Server 2022

Whether you are deploying a single ProLiant DL20 Gen10 for a branch office or a fleet of DL380 Gen10 servers, mastering the S100i driver saves hours of deployment headaches. Remember: In the world of HPE Gen10 software RAID, the driver is the bridge between your hardware and the operating system. Use the correct one, and Windows Server 2022 will run reliably. Ignore it, and you’ll find yourself staring at an empty disk selection screen.