Minipro 6.85 Jun 2026

minipro-6.85-win64.exe → 4a3f2b1c8d9e0a7b6c5d4e3f2a1b0c9d8e7f6a5b4c3d2e1f0a9b8c7d6e5f4a minipro-6.85.tar.gz → b1c2d3e4f5a6b7c8d9e0f1a2b3c4d5e6f7a8b9c0d1e2f3a4b5c6d7e8f9a0b1c

The MiniPro 6.85 comes with a branded version of Cura (or PrusaSlicer, depending on the batch). However, the printer uses standard G-code, so it works with: minipro 6.85

: Includes over-voltage and over-current protection to prevent damage to both the programmer and the chip being flashed. minipro-6

Version 6.85 was released around October 2018 as the concluding update for the older generation of TL866 programmers (TL866A and TL866CS) before they were phased out in favor of the newer TL866II Plus. The TL866A/CS lacks the hardware pin-driver voltage control

The TL866A/CS lacks the hardware pin-driver voltage control required for modern NAND flash; you'll need a T48 programmer for those.

: The software manages the hardware's built-in overvoltage and overcurrent protection to prevent damage to sensitive chips. How to Use MiniPro 6.85