Ap3g2-k9w7-tar.153-3.jbb1.tar Work -

In your terminal (e.g., PuTTY), enter the following commands in the prompt to set up the transfer: ap: format flash: ap: ip_addr

Using this image "converts" a lightweight (controller-based) access point into an autonomous one that works independently. 1. Prerequisites Ap3g2-k9w7-tar.153-3.jbb1.tar WORK

Release the MODE button once the light turns red (or when you see the prompt in your terminal). 3. Perform the Image Transfer In your terminal (e

AP 3702i - IOS version for Autonomous Mode - Cisco Community 06-Aug-2015 — In your terminal (e.g.

: Ensure you use k9w7 images for standalone use; k9w8 images are for Lightweight (Controller-based) mode and will not work for standalone site surveys or independent management.